TOPCOAT® POLYWASH™

• Safe for your finish: Unlike traditional soaps and washes, PolyWash™ will break up dirt and grime without damaging the surface. Perfect surface prep for F11®: PolyWash™ is specially formulated to bond with all TopCoat® Sealers.
• A little goes a long way: Our ultra-concentrated formula means you can use as little as 1oz per gallon of water! Our high-tech Micro-Bond™ coating leaves behind a water-repellent, protective shine.
• Use it in a sprayer, foam cannon, or the traditional bucket-- And get the same great results with whatever method you prefer! Wash, clean, shine, and protect with this one revolutionary product!

For General Purpose Cleaning:

• Use 2oz of PolyWash™ per gallon of water. For light cleaning use 1oz of PolyWash™ per gallon.
• Pour PolyWash™ into a bucket, then add water using the suggested ratio.
• Thoroughly wet the vehicle you intend to wash.
• Apply the mixed PolyWash™ to the wet surface using a sponge or wash mitt, wiping and washing the surface as you go.
• Rinse thoroughly and then dry after.

Spray Directions:

• Pour 1/2oz of PolyWash™ into a 32oz spray bottle already filled with water, then shake.
• Spray on surface and wipe off using clean microfiber towels a section at a time.
• Do not allow to dry before wiping clean.

For More Aggressive Cleaning:

• Spray PolyWash™ on a section at a time.
• Agitate surface with a cellulose sponge, microfiber wash mitt, or microfiber applicator pad.
• Then wipe off using a clean microfiber towel until dry.

Foam Canon Directions:

• Leave enough room to pour 1-2oz of PolyWash™ in a water filled foam canon container.
• Note: For more desired sudsing/foaming add extra PolyWash™.
• Connect foam cannon container to foam spray-head then shake to mix.
• Attach to hose and go!
• Rinse thoroughly and towel dry or blow off water.

Q. How much surface area does one bottle cover?

A. 1oz of PolyWash™ should cover approximately 440sqft of surface area. That means that a bottle will cover 7040sqft. To make this a little more practical, we recommend using 1oz in a gallon of water for a regular washing of your car, or 2oz in a gallon if it is particularly dirty.

Q. Will this remove wax? Will this clean off water spots?

A. PolyWash™ will not remove wax, and because it helps prep the surface to bond with our other products, it is the perfect product to use before applying a coat of F11®. PolyWash™ will not remove water spots, but due to the nature of the coating it applies, will significantly reduce the amount of new water spots that are able to form on the surface.